MEADE AUTOSTAR ASCOM DRIVER

Driver available here click me First release. You should be able to get the unbinned pixel size from the camera spec sheet or the manufacturer’s web site. Please contact Explore Scientific for more information. For the 16F, force LVP off in the check boxes. The park position can be changed using the Autostar II handbox only.

Uploader: Gorg
Date Added: 19 November 2011
File Size: 25.76 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 20834
Price: Free* [*Free Regsitration Required]

If you want to use the same equipment set-up with different binning levels, autostr best to create separate profiles for each binning value. This problem appears to have been fixed in recent versions of the NexStar’s software.

If your serial Bluetooth adapter’s serial number is or higher then the default baud rate is bps which is also the default baud rate for most telescope mounts and you can continue with paring the adapter with your computer as described below. This would cap you at 1. This is due to there being too many entries in the user data list that holds the autosgar setup info.

It appears to work OK, but all comments are welcome!

It contains both a Telescope driver as well as qutostar Focuser driver since the scope and focuser controls share the same serial port.

  D LINK DFE530TX DRIVER DOWNLOAD

Regulator if Focuser is added. Sounds like you’re doing everything right Many telescope models from different manufacturers support this 4-wire guide interface input albeit with different pins or signal polarities. You should be able to get the unbinned pixel size from the camera spec sheet or the manufacturer’s web site. The hand control serial port based only is then connected to the telescope mount.

Help! Meade lxgps ascom phd issue – Discussions – Mounts – Stargazers Lounge

Start Cartes du Ciel. Click here to download the NexStar 5 driver 13kb Clicking the above link will download a file called “N5.

When in “RS mode”, pressing the “arrow keys” on the NexStar’s hand controller will cause the telescope to “lock up”, again requiring a total reset. JPG Small cropped section from 4X: It should also work with TheSky6 and TheSky5 but not all functionality will be present.

It is possible, however, to re connect to a parked and optionally power-cycled LXGPS and bring it back online without interaction with the handbox.

Meade LX200 GPS and Classic

Please contact Explore Scientific for more information. Device-connection in the wizard is basically a convenience feature that makes it easier to fill in the fields with accurate values. Update Update Nov 14, These units are in continuous stock, available to ship in 2 days or 5 days. If you say ‘yes’ to the connection option prompt, PHD2 will attempt to read the current guide speed from the mount. This driver provides the following functionality: Schematic for PCB basic.

  IOGEAR USB TO PARALLEL DRIVER

Slew the telescope to point at any desired target. Aux Bus Tech info.

From Jameco no affiliation with them. Click here to download the sharedrv. The driver file is all that is required if you simply want to use the driver – the source code may be of interest to programmers.

Meade LX GPS and Classic

Equatorial mounts do not need to be accurately polar-aligned although an accurate polar alignment will likely lead to a more satisfying observing experience. Always compile with all optimizations off. This driver does NOT support Synta mounts.

The 1st option is for purists who need the raw scope behavior. The driver allows the Park Position to be changed.

Note that, to use this driver, the Skysensor must be set to use LX emulation mode.

Leave a Reply